Browse DigiKey’s inventory of THS Evaluation ModuleOp Amps. Features, Specifications, Alternative Product, Product Training Modules, and Datasheets. Texas Instruments THS Linear – Amplifiers – Instrumentation, OP Amps, Buffer Amps parts available at DigiKey. THS Price, THS Stock, Buy THS from electronic components distributors. Instant result for THS

Author: Shaktikree Gardagis
Country: Mozambique
Language: English (Spanish)
Genre: Science
Published (Last): 3 April 2012
Pages: 450
PDF File Size: 9.83 Mb
ePub File Size: 14.77 Mb
ISBN: 387-9-77446-548-5
Downloads: 35194
Price: Free* [*Free Regsitration Required]
Uploader: Maugis

TINA/Spice/THS3001: The TH3001 output decrease amplitude with frequency

I don’t think any of these devices are supposed to operate ths301 single 5V supply. No license, either express or implied, by estoppel or otherwise, is granted by TI.

Aug 2, 5: I try to implement an amplifier, but my PCB board always falls in noise as following figures: Aug 9, 9: This is not the case yhs3001 the output connector J3 because it seems to be referenced to GND. In reply to Rohit Bhat: Ask a ths3001 question Ask a new question. Oct 18, 5: Oct 10, Content on this site may contain or be subject to specific guidelines or limitations on use.

The newly created question will be automatically linked to this question. The newly created question will be automatically linked to this question.


If you have a related question, please click the ” Ask a related question ” button in the top right corner. Ask a related question What is a related question?

This thread has been locked. Aug 3, 2: Oct 13, 9: No license, either express or implied, by estoppel or otherwise, is granted by TI. And the noise still happened as follow figure: When reducing the ths301, the noise was smaller.

In reply to Darren Xu:. All content and materials on this site are provided “as is”. The other thing is that would it be possible for you to zoom-out on the oscilloscope screen shot to capture longer duration, and re-attach the scope screen shot? Hi again, May I ask that why the network analyzer show that chart. Locked Cancel Do you have another question? Ask a new question Ask a new question Cancel. If you have further questions related to this thread, you may click “Ask a related question” below.

THS Course synopsis

Following is my Schematic diagram. The device could be made more stable by increasing the Rf value or R5 in your case to 1kohms or higher. Trademarks Privacy Policy Terms of Use. And the output without input still noised. Hi Darren, It is common to notice the decrease in output amplitude across frequency for an amplifier, because of the BW roll-off across frequency. I also change Rf and Rg for ohm,but the problem does not change.


Use of the information on this site may require a license from a third party, or a license from TI.

TINA/Spice/THS3001: THS3001 Noise

In reply to Darren Xu: Aug 3, Hi Dinh, Would it be possible for you to make the R5 as 1kohms or higher and R6 as Oct 11, Also, I would refrain from using the THS because it is not recommended for new designs.

Tha3001 Rohit, I did not apply any input signal, but the noise still happened.

Is this noise captured with an input signal applied, or you are not applying any input signal and still getting this noise? Do you have another question?