Title, Curso de vapor Spirax Sarco. Contributor, Spirax Sarco (Firma). Publisher, Spirax Sarco, Length, 84 pages. Export Citation, BiBTeX EndNote. Curso de Vapor por Spirax Sarco, Tuvanosa, Calzada Aeropuerto # Pte Col. Nuevo Bachigualato, Culiacán, Mexico. Mon Oct 17 at. Curso de gestión impartido en Queretaro, gracias por confiar en Spirax Sarco. Expertos en soluciones de energía térmica y vapor. #atodovapor #spiraxsarco.

Author: Yokus Vojora
Country: Colombia
Language: English (Spanish)
Genre: Sex
Published (Last): 14 June 2016
Pages: 249
PDF File Size: 11.75 Mb
ePub File Size: 5.71 Mb
ISBN: 991-7-98871-525-2
Downloads: 53635
Price: Free* [*Free Regsitration Required]
Uploader: Mekasa

Therefore allowance should be made for this pressure loss when deciding upon the initial distribution pressure. If this build up continues, the tips of the waves will break vaplr, throwing droplets of condensate into the steam flow. Sizing one is not difficult as they are always sized to match the steam line line size.

¡La trampa de vapor más sustentable y de más rápida instalación!

Pressure required at point of use Pressure drop along pipe due to resistance of flow friction Pipe spirx losses We also know that steam at a higher pressure occupies less volume per kg. Sarcl must supply good quality steam at the required rate and at the right pressure. It therefore follows that if we generate spiras in the boiler at a much higher pressure than that needed by its application, and we distribute it at this higher pressure the bore of the distribution mains will be smaller for any given mass flow rate.


Steam leaving a boiler, or other sources, is often much wetter than is appreciated and if this water is not removed, there will be poor heat transfer at the point of use this is why the steam needs to be dry.

Steam lines are no exception. The result is that the heat exchange equipment receives very wet steam.

Spirax Sarco Colombia | First for Steam Solutions

Insulation will naturally spirx the heat loss, but sqrco heat flow and the condensation rate remain as small but finite amounts and if appropriate action is not taken these amounts will accumulate. This is one location where a correctly sized mechanical drain trap, such as a float trap, can be beneficial. The use of a separator to remove this moisture is shown in the slide. The pressure at which the steam is to be distributed is determined by the point of usage on the plant needing the highest pressure.

We must remember however that as the steam passes through the distribution pipework, it will lose some of its pressure sarrco to resistance to flow, and the fact that some of it will condense due to loss of heat from the pipes.

This causes considerable damage to the pipework and ancillaries.

If this build up continues, the tips of the waves. If taken from the side, or even worse from the bottom, they can carry the condensate from the satco and in effect become a drain pocket.


Summarising, we need to consider when selecting our working pressure: The result is very wet steam reaching the equipment. The condensate will form droplets on the inside of the pipe wall, and these can merge into a film as they are swept along by the steam flow. Steam flowing over this film can raise ripples which can build up into waves.

It must do this with the minimum of heat loss, and be economical in capital cost.

As soon as steam has left the boiler, some of it must condense, to replace the heat being lost through vaor pipe wall. We already know that dry saturated steam not superheated is to be used for process and heating applications and it is that with which we shall concern ourselves.

The film will also gravitate towards the bottom of the pipe, and so the thickness of the water film will be greatest there.

Enviado por Luiz Felipe flag Denunciar.