ASTM D6938 PDF

ASTM D Standard Test Methods for In-Place Density and Water Content of Soil and Soil-Aggregate by Nuclear Methods (Shallow Depth). depth, etc.) Verify proper rebar sizes and placements. Verify proper reinforcing overlaps. Verify proper clearance and that chairs are. ASTM D Uploaded by Xavior. Standard Test Method for In-Place Density and Water Content of Soil and Soil- Aggregate by Nuclear Methods (Shallow.

Author: Muzil Fautaxe
Country: Tanzania
Language: English (Spanish)
Genre: Medical
Published (Last): 4 October 2016
Pages: 197
PDF File Size: 6.34 Mb
ePub File Size: 6.94 Mb
ISBN: 809-5-81181-468-1
Downloads: 10149
Price: Free* [*Free Regsitration Required]
Uploader: Kagarisar

The total or wet density of soil and soil-aggregate is measured by the attenuation of gamma radiation where, in direct transmission, the source is placed at a known asstm up to mm 12 in. The values in inch-pound units ft — lb units are provided for information only.

Reliable results depend on many factors; Practice D provides a means of ast, some of those factors. The nondestructive nature allows repetitive measurements at a single test location and statistical analysis of the results.

The water mass per unit volume is determined by the thermalizing or slowing of fast neutrons by hydrogen, a component of water.

ASTM D Standard

Request Quote Client Login. Soil testing Field Services: It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. In addition, they are representative of axtm significant digits that should generally be retained.

  ASTM D5470 PDF

It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design. Measurements for water moisture content are taken at the surface in backscatter mode regardless of the mode being used for density.

Active Risk Management

The water content most prevalent in engineering and construction activities is known as the gravimetric water content, w, and is astmm ratio of the mass of the water in pore spaces to the total mass of solids, expressed as a percentage.

The dry density of the test sample is obtained by subtracting the water mass per unit volume from the test sample wet density Section Measurements for water d6983 content are taken at the surface in backscatter mode regardless of the mode being used for density. Most gauges display this value directly. For more information, contact: Most gauges display this value directly.

Historical Version s – view previous versions of standard. For Individuals with needing special assistance for disabilities or limited English proficiency Please contact our Title VI specialist at Soil testing Back to Results Print. This places the gamma and neutron sources and the detectors in the same plane.

  IETF RFC 3588 DIAMETER BASE PROTOCOL PDF

Link to Active This link will always route to the current Active version of the standard. D698 test method describes the procedures for measuring in-place density asmt moisture of soil and soil-aggregate by use of nuclear equipment. When divided by the density of water and then multiplied bythe water mass per unit volume is equivalent to the volumetric water content.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The neutron source d6398 the thermal neutron detector are both located at the surface of the material being tested. The density of the test sample in mass per unit volume is calculated by comparing the detected rate of gamma radiation with previously established calibration data.

The direct transmission is the preferred method.

Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results. The quality of the result produced by this standard test method is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used.